Pays Fall Precision Tune Up
- Check Filters
- Inspect and tighten electrical connections
- Check heat exchanger for cracks
- Inspect evaporator coil for dirt, rust, or debris
- Blow out condensate drain
- Clean burner assembly
- Clean heat exchanger
- Clean and adjust pilot if applicable
- Vacuum area around furnace
- Check UV light if applicable
- Check gas connections
- Check blower motor amperage
- Check for gas leaks
- Check induction motor
- Check return and supply static pressure
- Check combustion air
- Check thermostat and calibration
- Test safety controls
- Cycle A/C & heat at thermostat to make sure both operate
- Record condition, age of equipment, model/serial numbers and recommendations
- Clean up any trash around work area
|
Spring Precision Tune Up
- Monitor cooling capacity levels for optimal performance.
- Check temperature differentials across the coil.
- Inspect all high-voltage connections.
- Ensure the thermostat is working correctly.
- Check for evaporator coil restrictions.
- Replace air filters.
- Disinfect the return air chamber and blower.
- Monitor the blower motor for high-amp draw.
- Inspect the blower motor bearings.
- Check the blower wheel for restrictions.
- Test the blower motor capacitor.
- Monitor the compressor for high-amp draw.
- Inspect the condenser fan motor for high-amp draw.
- Check all electrical wiring for loose connections.
- Clean the condensate drain line to prevent backups.
- Wash the condenser coil.
- Check the contactor for issues.
- Test the compressor capacitor.
- Inspect and test any circuit boards.
- Check the electrical breaker.
- Test start kits for compressors.
|